1. Investigación

An in-capillary sample preconcentration strategy based on solid phase extraction (SPE) technology coupled with capillary electrophoresis (CE) has been developed taking advantage of both techniques (SPE and CE). An in-line frit-free preconcentration device for capillary electrophoresis containing MCX beads, obtained from the corresponding Waters OASIS® cartridges, was prepared. The retention of the particles was based on the relative diameters of the particles, carefully selected, and the capillaries. An experimental preconcentration factor of 100 was found for the system. Conditions were optimised for 3-nitrotyrosine measurement in rat urine being 4.4 M spiked in the urine the lowest value detectable.

Capillary electrophoresis (CE) poses unique challenges in many different analytical applications, mainly to biological and complex samples and when only small amounts of sample are available, due to its low sample consumption. As a consequence, poor limits of detection are usually observed with this technique, especially with UV photodetectors. Minimal or no sample treatment is desirable in any analytical method to avoid external sources of contamination or errors and to provide a high throughput. On- and in-capillary sample pre-concentration strategies, based on solid-phase extraction (SPE) technology can take advantage of both techniques (SPE and CE), while avoiding sample contamination and tedious manipulations when the sample amount is an issue. Moreover, the combination can provide two-dimensional separations. This review collects the most recent strategies that merge SPE technology built on- and in-capillary pre-concentration for increasing sensitivity and/or selectivity.

Short chain organic acids play an important role in different areas such as biochemistry, clinical chemistry, or the food industry. The enantiomeric ratio of chiral metabolites is an important parameter for the understanding of metabolic processes and in many cases it can serve diagnostic purposes. On the other hand, the presence of racemates in food products could indicate the use of organic acids as additives; this is not always permitted and needs to be controlled. The short chain of these acids makes difficult the three point interaction generally accepted as necessary for chiral recognition. Relatively recent publications have demonstrated the feasibility of their direct chiral separation in capillary electrophoresis by various techniques utilizing exchange capillary electrophoresis, macrocyclic antibiotics, cyclodextrins, ion-pair method, and transition metal complexes. The present article describes existing methods and strategies proposed to advance these areas.

Renal stone disease is an ancient and common affliction, common in industrialised nations. The causes and incidence of nephrolithiasis are presented. Afterwards, the promoters and inhibitors of renal stone formation analysis in urine are described including enzymatic methods, chromatography, capillary electrophoresis and other techniques. Aspects such as sample collection and storage are also included. The review article includes referenced tables that provide summaries of methodology for the analysis of nephrolithiasis related compounds.

Fruit juices each have very distinct organic acids profiles that can be used as fingerprints for establishing authenticity. A method has been developed, optimised and validated for measuring by capillary electrophoresis citric, isocitric, malic and tartaric acids as authenticity markers in orange juices, without any sample treatment other than dilution and filtration. Final conditions were phosphate buffer 200 mM, pH 7.50, 214 kV as applied potential, and 57 cm length neutral capillary. Detection was direct UV at 200 nm. Different kinds and marks of orange juice, chosen from the great variety existent in the market, were analysed and clear differences could be found between them and just pressed orange juice.  2000 Elsevier Science B.V. All rights reserved.

The optimization of a HPLC method for caffeine, 8-chlorotheophylline and diphenhydramine separation with UV detection at 229 nm is described. The conditions studied included: stationary phase, compositions of mobile phases with pH modulators. Optimal conditions were: SymmetryShield RP8 column and acetonitrile–(0.01 M H PO –triethylamine, pH 2.8) 3 4 (22:78, v/v). Validation was performed using standards and a pharmaceutical preparation containing the compounds described above. Results from both standards and samples show suitable validation parameters. The pharmaceutical grade substances were tested by factors that could influence the chemical stability. These reaction mixtures were analyzed to evaluate the capability of the method to separate degradation products. Degradation products did not interfere with the determination of the substances tested by the assay.

This review article is a comprehensive survey of capillary electrophoresis methods developed for the measurement of short-chain organic acids and inorganic anions in a wide variety of matrices, such as food and beverages, environmental, industry, and other applications, as well as clinical applications in body fluids such as urine, plasma or cerebrospinal fluid. Details of sample pretreatment and of electrophoretic conditions have been collected in tables, arranged by the type of matrix. Strategies employed for method development for the analysis of these compounds by capillary electrophoresis in real samples are discussed.

A capillary electrophoresis method has been developed and validated for acetic, citric, fumaric, lactic, malic, oxalic, succinic, and tartaric acids plus the measurement of nitrate and sulfite ions in white and red wines. The separation was carried out in a neutral coated capillary. Separation was performed at 14 kV of applied potential. Temperature was maintained at 20 C. The background electrolyte used was 200 mM phosphate buffer at pH 7.50. Separation was obtained in less than 13 min. Validation parameters obtained for the method permit it to be considered adequate for routine analysis.

This review article is a comprehensive survey of capillary electrophoresis methods developed for the measurement of short-chain organic acids and inorganic anions in a wide variety of matrices, such as food and beverages, environmental, industry, and other applications, as well as clinical applications in body fluids such as urine, plasma or cerebrospinal fluid. Details of sample pretreatment and of electrophoretic conditions have been collected in tables, arranged by the type of matrix. Strategies employed for method development for the analysis of these compounds by capillary electrophoresis in real samples are discussed.