Dpto. Odontología

The contemporary approach for operative caries management emphasizes personalized interventions for each patient, dependent upon the individual’s caries susceptibility/risk, the stage of the carious lesion and its activity. The clinician’s challenge is to optimize the extent of cavity preparation and the choice of dental restorative biomaterials, appreciating the benefits offered by ionreleasing restorative materials. There is a growing application of bioactive/bio-interactive materials in minimally invasive operative dentistry, as they may help with tissue recovery by ion release. In case of moderate or extensive occlusal cavitation, the clinical criteria include the individual caries susceptibility and carious lesion activity. In high caries risk cases, ion-releasing biomaterials (IRB) can be used, as well as for active carious lesions. In proximal lesions, the clinical criteria include the individual caries susceptibility, the lesion activity and presence of cavities with little or no enamel at the gingival margin. This article aims to discuss the restorative ion-releasing options, according to different clinical situations, and the caries susceptibility to manage cavitated carious lesions in permanent adult teeth.

The present study aims to evaluate the effectiveness of an XP-endo non-surgical root canal re-treatment system in removing both GuttaCore and Thermafil gutta-percha carrier-based root canal filling materials from straight root canal systems using micro-computed tomography (micro- CT) analysis. The study was performed on 20 single-rooted upper teeth, which were randomly allocated into the following study groups: Group A, Thermafil and AH Plus sealer (n = 10); Group B, GuttaCore and AH Plus sealer (n = 10). Before and after the non-surgical root canal re-treatment procedure, the samples were submitted for a micro-CT analysis. The volume of the root canal filling material (mm3), the volume of the remaining root canal filling material (mm3) and the time (minutes) needed to remove the root canal filling material were also recorded. Student’s t-test was used to analyze the results. No statistically significant differences were found between the volume of the remaining root canal filling material in the GuttaCore and Thermafil root canal filling systems at the coronal third (p = 0.782), middle third (p = 0.838) or apical third (p = 0.882) of the straight root canal systems; however, the GuttaCore required a statistically significant (p = 0.037) shorter amount of time (4.72 0.76 min) to be removed than the Thermafil carrier-based root canal filling material (5.92 1.42 min). The XP-endo Finisher non-surgical endodontic re-treatment system removes both GuttaCore and Thermafil gutta-percha carrier-based root canal filling materials from straight root canal systems, although removal of the GuttaCore gutta-percha carrier-based root canal filling material required less time.

This study evaluated the influence of an aqueous propolis-based solution (PROP) on gap formation and bond strength of posts bonded to root canal dentin using resin cements. Endodontically-treated bovine incisors received different irrigation protocols: 1) 2.5% sodium hypochlorite (NaOCl)/17% EDTA/NaOCl; 2) saline solution (NaCl)/EDTA/0.12% chlorhexidine (CHX); 3) NaOCl/PROP/ NaOCl; 4) NaCl/PROP/CHX; 5) NaCl/PROP/NaCl. Posts were then bonded with cements: RelyX ARC; Panavia F2.0; or RelyX U200 (n=10). The specimens were cross-sectioned. Gaps were assessed and performed the push-out bond strength test. Surface roughness of dentin fragments was also evaluated. Statistical analysis was performed (5%). RelyX U200 exhibited greater gap-free interfaces. Bond strength varied as a function of cements and irrigation protocols. PROP irrigation had no negative effect on the bond strength (p>0.05). Roughness increased significantly after NaOCl/EDTA/NaOCl, but remained unaltered after PROP irrigation protocols. Propolis-based irrigation protocols do not interfere in the bonding performance of posts cemented to root canal dentin.

Objective The purpose of this research was to investigate the effect per se of two shaping and cleaning techniques on the reduction of an in vitro multispecies biofilm. Materials and Methods A total of 39 freshly extracted monoradicular teeth for periodontal reason were decoronated. Roots were sectioned longitudinally. After autoclaving, a specific stressed biofilm was grown on the root halves that were subsequently reassembled in a silicone index. Two treatments (n = 9 each)—RaCe (Schottlander; Letchworth Garden City, United Kingdom) and ProTaper Gold (PTG; Dentsply Maillefer, Baillagues, Switzerland)—were tested; three noninstrumented samples served as a control group and three were rinsed with saline. Posttreatment samples were taken at three different levels of the root. Colony-forming units were counted after incubations. Additionally, three treatments (n = 5 each)—RaCe, PTG, and saline only—were evaluated under a confocal laser scanning microscope (CLSM). Statistical Analysis Statistical analysis was conducted using Tukey’s test and analysis of variance to evaluate the post-instrumentation bioburden. Results Both instrumentations were able to reduce the biofilm; however, differences were not present between them (p > 0.05). CLSM showed biofilm killing and disruption through mechanical shaping alone. Conclusions Intraradicular biofilm is reduced with mechanical shaping. There was no difference between RaCe and PTG systems in biofilm reduction despite differences in design, file sequence, and rotational speed.

Introduction: This study compared bacterial percolation and sealer penetration of a novel obturation technique with the ones of warm vertical condensation technique. Methods and Materials: A bacterial percolation test was carried out with 80 single rooted human teeth divided into 5 groups; A (n=20): warm vertical condensation and AH-Plus, B (n=20): CPoint with AH-Plus, C (n= 20): CPoint with EndoSequence BC, +ve Control (n=10): teeth with no canal obturation, -ve Control (n=10): teeth with no access cavity. The samples were inoculated with a multispecies bacterial incoulum. Bacterial percolation was evaluated by turbidity. Confocal laser scanning microscopy (CLSM) was used to observe the presence of gaps and voids. Further 48 extracted human mandibular single-canal premolars were used to determine the sealer penetration. Slices of the samples were observed by CLSM to evaluate tubules penetration of the sealer. Kaplan Meyer survival, ANOVA one way and Tuckey HSD test and a Wilcoxon signed-rank test were utilised. Results: A Kaplan-Meier test showed no significant difference overall (P>0.05) between groups A, B and C. At 43 days, the group B showed a significantly inferior ability to prevent bacterial passage (P<0.05). The group C showed a deeper sealer penetration than group A and B with statistically significant differences (P<0.05) for the total penetration (ANOVA one way and Tukey HSD). A Wilcoxon signed-rank test showed statistically significant differences for the penetration in the middle-and apical third of the 3 groups. Conclusion: Based on this in vitro study, the single polymer-cone obturation technique with a resin based- and bioceramic based-sealer behaved similarly to the warm vertical obturation technique in preventing bacterial passage. The bioceramic sealer showed the deepest penetration but did not fully prevent bacterial leakage.

The objective of this systematic review was to determine the influence of surface treatment of glass fiber posts on bond strength to dentine. Laboratory studies were searched in MEDLINE, PubMed, Embase, PubMed Central, Scopus, and Web of Science search engine. All authors interdependently screened all identified articles for eligibility. The included studies were assessed for bias. Because of the considerable heterogeneity of the studies, a meta-analysis was not possible. Twelve articles were found eligible and included in the review. An assessment of the risk of bias in the included studies provided a result that classified the studies as low, medium, and high risk of bias. The available evidence indicated that the coronal region of the root canal bonded better to the glass fiber post than apical regions. Phosphoric acid, hydrogen peroxide, and silane application enhance post’s retentiveness. In light of the current evidence, surface treatment strategies increase the bond strength of glass fiber post to dentine. However, recommendations for standardized testing methods and reporting of future clinical studies are required to maintain clinically relevant information and to understand the effects of various surface treatment of glass fiber post and their bond strength with dentine walls of the root canal.

This study aimed at evaluating the e cacy of a novel silver-citrate root canal irrigation solution (BioAKT) on smear layer removal, sealer penetration after root canal instrumentation and antibacterial activity. Single-root teeth were endodontically treated, sealed with an epoxi-amine resin sealer and irrigated using: Group I: 5.25% sodium hypochlorite (NaOCl); Group II: silver-citrate solution (BioAKT); Group III: phosphate bu er solution (PBS); Group IV: 17% ethylenediaminetetraacetic acid (EDTA). Smear layer removal and silver deposition at the coronal, middle and apical portion of each canal were analyzed using scanning electron microscopy (SEM) and energy-dispersive x-ray spectroscopy (EDS). Sealer penetration into dentinal tubules at coronal, middle and apical portion was assessed through dye-assisted confocal microscopy (CSM). Both SEM and CSM micrographs were evaluated by two examiners ( = 0.86), who were blind to the irrigation regimens; scores were given according to the degree of penetration of the sealer. Data analysis included Pearson’s x2 and Sidak’s multiple comparisons. Dentin discs were polished and sterilized. Enterococcus faecalis biofilms were grown using a continuous-flow bioreactor under anaerobic conditions for 72 h. Specimens were irrigated with the tested solutions, and bacterial viability was assessed using a tetrazolium salt assay (MTT). Statistical analysis included one-way ANOVA and Student’s post-hoc t-test (p < 0.05). BioAKT and EDTA were the most e cient solutions both in removing the smear layer and allowing sealer penetration. However, at the apical portion BioAKT performed significantly better compared to EDTA both in smear layer removal and sealer penetration (p < 0.05). BioAKT and NaOCl showed comparable antibacterial e ect (p = 0.53). In conclusion, BioAKT represents a suitable smear layer removal agent, which allows for reliable sealer penetration at the apical portion of the root canal system and o ers significant antibacterial properties.

Background: The objective was to evaluate the e ciency of ProTaper Gold (PTG) and Reciproc Blue (RB) NiTi files in obturation material removal from straight root canals assessed by micro-computed tomography. Methods: Fifty-two anterior human teeth were shaped with a PTG rotary system until F2 (25/.08). Specimens were obturated with a continuous wave of condensation technique. For retreatment, specimens were randomly distributed in two experimental groups: PTG group (F4 file) and RB (R40 file). Micro-CT scans were performed before and after retreatment procedures. The percentage of the remaining obturation material compared to the original volume was calculated, as well as the retreatment time. The presence of separated files was recorded. A descriptive analysis was carried out, and nonparametric tests were employed. Results: The mean percentages of remaining obturation material in the PTG group and the RB group were 4.14 4.30% and 4.18 4.29%, respectively. The mean retreatment times for the PTG and RB groups were 144 51 and 163 88 s, respectively. There were no statistically significant di erences, neither in removal e ciency (p > 0.05) nor in retreatment time (p > 0.05), between the two groups. The coronal and middle thirds presented significantly more remaining obturation material than the apical third (p < 0.05). No file separation occurred. Conclusions: ProTaper Gold and Reciproc Blue present with comparable e ciency in removing the obturation material, with a similar mean retreatment time.

To investigate the influence of pre-endodontic coronal wall restoration on smear layer removal during di erent root canal irrigation strategies, single-root premolars were prepared with a mesio-occlusal cavity. Half were left untreated (G1), while the mesial walls of the remaining half were reconstructed using a resin composite (G2). The specimens were divided into control (ctrl) groups, which used the conventional needle irrigation method, and four experimental subgroups according to irrigation strategy: Sonic activation using the Endoactivator, sonic activation using the EQ-S, mechanical activation using the XP-Endo finisher, and ultrasonic activation using the EndoUltra. Smear layer removal was assessed through SEM and the results were statistically analyzed. At the coronal and middle thirds, no significant di erence (p > 0.05) was detected for G1 and G2, except for the control subgroups (G1ctrl vs G2 ctrl) at the middle third. At the apical third, the smear layer removal was significantly greater for G2 than G1. In G1, both at the middle and apical level, EQ-S and EndoUltra showed greater smear layer removal (p < 0.05) compared to the others G1 subgroups. In G2, at the apical level, the EQ-S and EndoUltra were the most e ective in smear layer removal. Pre-endodontic coronal wall restoration may improve the smear layer removal during root canal irrigation.

The aim of this study is to analyze and compare the e cacy of three non-surgical endodontic retreatment techniques in removing a carrier-based root canal filling material from straight root canal systems. The study was performed on 99 single-rooted extracted teeth using the ProTaper Gold endodontic rotary system up to the F2 file (Dentsply Maillefer, Baillagues, Switzerland), which were sealed with GuttaCore (Dentsply Maillefer, Ballaigues, Switzerland) and AH plus epoxy resin sealer (Dentsply DeTrey, Konstanz, Germany) and randomly assigned to the following non-surgical retreatment techniques: ProTaper Retreatment endodontic rotary instruments (D1–D3 files, Dentsply Maillefer, Ballaigues, Switzerland; n = 33, PTR), Reciproc Blue endodontic reciprocating instrument (R50, VDW, Munich, Germany; n = 33, RCB50), and a combined root canal retreatment technique between Gates-Glidden drills (sizes #3 and #2, Dentsply Maillefer, Ballaigues, Switzerland) and Hedstrom files (file size 35, 30, and 25, Dentsply Maillefer, Ballaigues, Switzerland; n = 33; H-GG). All of the teeth were submitted twice to a micro-computed tomography (micro-CT) scan, before and after non-surgical endodontic retreatment procedures. The volume of root canal filling material (mm3), volume of remaining root canal filling material (mm3), non-surgical endodontic retreatment working time (min), proportion of remaining root canal filling material (%), and e cacy of root canal filling material removal between the non-surgical endodontic retreatment techniques were analyzed using ANOVA one-way statistical analysis. Statistically significant di erences were observed between the proportions of remaining root canal filling material of PTR and H-GG (p = 0.018), between the non-surgical endodontic retreatment working times (min; p < 0.001), and between the e cacies of root canal filling material removal by the non-surgical endodontic retreatment techniques (p = 0.009). However, the non-surgical endodontic retreatment systems allow for similar carrier-based root canal filling material removal.